top of page

ll

Feederleader Boss 2 Wht.png

The Boss II three-point-linkage single bale feeder is the most reliable and efficient feeder on the market. 

Understanding the demands of the modern farmer and time spent behind the wheel of a tractor were essential in the design and build of The Boss and its durability is testament to years of working in the field with the farmers that use them.​​

​

Round and square bales​

The Boss II is designed to feed out both round and square bales (with the addition of a square bale kit*) efficiently, eliminating the need to buy a second machine. 

​​

Feeds out both sides

It doesn't matter which way the bale is loaded into the cradle as a reversible drive system enables feeding from both sides, making it easier when working on the side of a hill.

​

Chain  ​

With a 15 000lb, 12mm ⌀ solid pin roller chain there will never be a need to replace the guided roller chain. Weight is absorbed by rollers not bars delivering a very quiet operation.

​​

Enclosed drive shaft 

The drive shafts are fully enclosed to prevent silage/hay from wrapping around moving parts resulting in congestion and loss of power.

​

Drive system

A one piece, cast iron drive system means there is more surface for the drive dog to drive on and will not break as opposed to pins. A 400cc heavy duty, hydraulic motor powers the drive shaft directly with no primary drive chains and allows the direct transfer of power with less parts to wear.

 

Body

The feeder body is fully enclosed (floor, front, back) meaning there is no wastage of feed through the cradle and its curvature ensures every last bit is fed out. The feed bed is made of pressed steel for extra strength and durability.

​​

Bushes

The unique design incorporates 4 bushes instead of bearings, which can corrode over time with the acid secreted from silage. The bushes are low maintenance with only four grease nipples needed to maintain the whole machine. 

 

Mounting

The cradle is designed to sit close in to the tractor and keep weight on the back axle, preventing flexing. A sliding top-link allows maneuverability while reconnecting forks to the cradle. Different fork lengths make it easier to line up. These solid forks are welded in.The feet run the width of the machine so that they don't dig into the ground and are angled perpendicular across the body to prevent sliding while mounting.

​

Bars

The bars on the Boss feeder range are welded directly onto the guided roller chain rather than just bolted ensuring optimum strength at the point of contact. Box section bars bear significantly more weight than angle iron.  The spikes are also welded onto the bars rather than bolted on.

​

​

​

​

​

​​

​ Boss Feeder                          

 North Island $10,950 + GST

 South Island $11,850 + GST                                  

 Square bale kit $990 + GST exc freight

 Hydraulic ram $650 + GST exc freight 

 

  ​

​

​

​

 

​
  Specifications

   Weight

   Width

   Length

   Hydraulics 

    Size of bales (round)

   Motor

   490kg
   2m
   1.8m

   1 x double acting

   4'x4'-6'x5

   400cc

   Drive system

   Direct drive

   Chain

   15 000lb solid pin           roller chain

Square bales attachment

Availible in the US, enquire Here

Availible in the Australia, enquire Here

bottom of page